To obtain your registration code, please send an email to [email protected]
Thread Rating:
  • 10 Vote(s) - 3.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

2004 E500 - DTC code 200A

1
Hello, sorry it got auto corrected to, should be E500

I have this code in the ETC



200A Component Y3/8n4 (fully intergrated transmission control (VGS) control unit) is defective

I believe this is usually the TCM with the valve body.

Anyway to check if this is not the conductor plate....

ALSO, any way to perhaps clone this TCM with a used unit or attempt to repair it

Thanks
Thanks given by:
2
If it's a NAG2 valve body and you can read the data from the control unit then you can replace the conductor plate/control unit only... You will have to flash and online code it..
________________________________________________________________________________​______

Remember the THANKS and + buttons if this helps you... It just makes me feel good
Thanks given by: MegaCar , Rabih AMG
3
No need to replace valve body, just change the VGS with a used one, make virgin with AVDI or FVDI, then offline programming in das with teach-in and the selector adaptation. After that put the 4 chars coding in the installed VGS (you can read it from old control unit, but if the numbers of the old and new VGS aren't the same then you need a different coding...)
Thanks given by:
4
(02-01-2017, 10:13 AM)Rabih AMG Wrote: No need to replace valve body, just change the VGS with a used one, make virgin with AVDI or FVDI, then offline programming in das with teach-in and the selector adaptation. After that put the 4 chars coding in the installed VGS (you can read it from old control unit, but if the numbers of the old and new VGS aren't the same then you need a different coding...)


Can I do this at the bench? I just pulled the conductor plate and it has VGs

[Image: JhFqmTc.jpg]


Must I find the identical numbers, I don't have AVDI or FVDI, perhaps it's time to buy it
Thanks given by:
5
(02-02-2017, 05:05 AM)BigK Wrote:
(02-01-2017, 10:13 AM)Rabih AMG Wrote: No need to replace valve body, just change the VGS with a used one, make virgin with AVDI or FVDI, then offline programming in das with teach-in and the selector adaptation. After that put the 4 chars coding in the installed VGS (you can read it from old control unit, but if the numbers of the old and new VGS aren't the same then you need a different coding...)


Can I do this at the bench? I just pulled the conductor plate and it has VGs

http://imgur.com/JhFqmTc


Must I find the identical numbers, I don't have AVDI or FVDI, perhaps it's time to buy it

You can virginize it at the bench but you need AVDI or FVDI with a special cable that fits to the conductor out of the car. For programmimg, the VGS must be connected to the vehicle (you can do this without installing the conductor into the car, but must be connected to the car).

You can replace VGS with a different part number like 73 or 03 (instead of 66), but then the coding of the old VGS will not fit the new one, so you need a new coding or you can online.

Regards.
Thanks given by: Rocinante
6
The big question.... How to know if the used one is good? Any tests to perform?

Having trouble finding them, is it possible to fix the original?
Thanks given by:
Users browsing this thread: