CM2220 Scanmatik

Hello,

I am looking for a way to read a Cummins CM2220C ECU using SCANMATIK.

So far, the only solution I have found is Multiprog in boot mode, but I do not have a Multiprog. I have also seen that ECU Alex Flasher supports this ECU via OBD.
Does anyone know of any other software compatible with SCANMATIK that can read and write the CM2220C in boot mode?

Any suggestions would be greatly appreciated.

Hello,

I am looking for a way to read a Cummins CM2220C ECU using SCANMATIK.

So far, the only solution I have found is Multiprog in boot mode, but I do not have a Multiprog. I have also seen that ECU Alex Flasher supports this ECU via OBD.
Does anyone know of any other software compatible with SCANMATIK that can read and write the CM2220C in boot mode?

Any suggestions would be greatly appreciated.

Hello, Combiloader

Why make things hard ? scanmatik + calterm

I currently have INSITE and Calterm, but I am not experienced enough to use them properly. I have received several files intended to restore the ECU to its original configuration. However, I still require a complete solution for EGR OFF, DPF OFF, and full removal of Engine Protection.

For this reason, I am looking for an experienced person who could perform the work remotely. I am, of course, willing to pay for the service. Any recommendations would be greatly appreciated.

I can assist you