EDC16CP42 immo off solution required

Hello guys,

I have put a a V9X nissan/renault engine into a friends Jeep Wrangler and have it all up and running with two keys (Jeep is can bus and Nissan is high current switching ignition switch), I have to use the Nissan Immobiliser to unlock the Nissan ECU and it would be very nice to remove all this, Im going to use a raspberry Pi to make the can comms interface (tacho, engine light, etc..)

Anyway, I hope someone out there might be able to point me in the right direction.

Thanks, Gareth.

Anybody have any ideas?

Just incase there is somebody out there that can help I thought I'd post the files but it seems Im not allowed post a bin file. I can email them if anybody want?

You can't disable Immo in bin from Flash.
You need EEPROM too.

You can't disable Immo in bin from Flash.
You need EEPROM too.

I have eeprom and bin files ready to send

You can't disable Immo in bin from Flash.
You need EEPROM too.

I have eeprom and bin files ready to send

Hi, did you did you get the Immo problem solved?
I have same problem with Navara 3.0 V6 DCI,
ecu was dead so I want to replaced it with a second
hand one, for that I need Immo off (or maybe virgin if it is possible to adapt it with Nissan OEM diagnostic)
maybe the Nissan guys can help? =)

I have still not found the answer to this issue.

I know this is a little old now, but am still looking for ideas

Hi

dont waste your time,dont exist immo off solution ! the only one solution are to virrgin eep and recode ecu with OEM tool,