EDC16U1 LIMP MODE DISABLE

does anyone knows if i can disable limp mode in this ecu edc16u1 .... i have a large hybride turbo larger injectors  its not a street car .... all i want is to disable limp mode...if anybody has an example with adress for limp mode pls poste an example file

There are usually 3 curves for limpmode torque limiting on these. But depends on sw. Without ori: Witless

And: Often much more is needed to make a stupid zombie-ecu... (limitating-factors, disabling some functions,...)

There are usually 3 curves for limpmode torque limiting on these. But depends on sw. Without ori: Witless

And: Often much more is needed to make a stupid zombie-ecu... (limitating-factors, disabling some functions,...)

From my side, I propose to delete DTC causing limp mode, or change conditions of DTC. Also I would change limits over pressure etc. You didn't write what is a cause of limp mode - you should begin from it.

There are usually 3 curves for limpmode torque limiting on these. But depends on sw. Without ori: Witless

And: Often much more is needed to make a stupid zombie-ecu... (limitating-factors, disabling some functions,...)

From my side, I propose to delete DTC causing limp mode, or change conditions of DTC. Also I would change limits over pressure etc. You didn't write what is a cause of limp mode - you should begin from it.

the car runs fine accelerates fine ....new turbo new wg new n75 all new the onlly problem is it goes in limp mode when the car drives with low boost  for example when you drive in the second gear 2000 rpm steady ... it happens to go in limp mode  this is why my question was do you know if i can disable the limp mode  ,,,, cause the rest i havew checked all ... and some othe people are having the same problem but they did not find solution ... the car pc detects underboost