To obtain your registration code, please send an email to [email protected]
Thread Rating:
  • 16 Vote(s) - 2.44 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Mileage correction on merc w221

1
Hi guys I am struggling to do mileage on a 2009 merc w221 I do it obd via the plug then it just jumps back then I take out the eis/ezs and there is no mask on it so I do not know we're I must solder to be able to put the mileage on 0 on the eis/ezs can somone please help with soldering points or evan a mask number so I can access the eis/ezs

Sent from my SM-G935F using Tapatalk
Thanks given by:
2
cannot do this type like that, you need to fit filter/blocker in eis and do dash onlyFing32
Thanks given by:
3
or you have to buy a expencive tool for it ..... for example DP4 do it
Thanks given by:
4
you can do it with avdi obd, there is instruction how to do it step by step in the abrites manual, you can do all control unit with it. i did 6 w221 without any issues, need like 1.5 to 2 hours to finish it. it block can between ic and eis.
Thanks given by:
5
I only have the r270 at the moment and digiprog so I think can blockker is going to be the cheapest way

Sent from my SM-G935F using Tapatalk
Thanks given by:
6
(01-06-2017, 02:54 AM)Robert AMG Wrote: you can do it with avdi obd, there is instruction how to do it step by step in the abrites manual, you can do all control unit with it. i did 6 w221 without any issues, need like 1.5 to 2 hours to finish it. it block can between ic and eis.

so with avdi you do not need to fit blocker/filter ?

or you have to buy a expencive tool for it ..... for example DP4 do it

with this tool is it all obd ??
Thanks given by:
Users browsing this thread: