Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Fuso EDC17 ktag help

1
trying to read/write a fuso bosch edc17 to scrub immo off
via the kessv2
got my pins as follows

pin 1 ground
pin5 12v
pin 92 12v
pin 87 green
pin 67 yellow

no comms as yet, is there any jump wire thats needs to be put on the bored?
dont have any diagrams for this modal ecm


thanks and rep in advance 
Never eat yellow snow
Thanks given by:
2
(11-11-2019, 02:31 AM)gazchopper Wrote: trying to read/write a fuso bosch edc17 to scrub immo off
via the kessv2
got my pins as follows

pin 1 ground
pin5 12v
pin 92 12v
pin 87 green
pin 67 yellow

no comms as yet, is there any jump wire thats needs to be put on the bored?
dont have any diagrams for this modal ecm


thanks and rep in advance 
You need Ktag
Thanks given by: gazchopper
3
can it not be done via

kessv2
bootloader tricore
bosch edc17 mitsubishi ???
via the protocols menu??

so is there no need to put a jump wire or resistor across the bored anywhere?
Never eat yellow snow
Thanks given by:

Possibly Related Threads…

 
Replies: 1
Views: 343
2 hours ago
Volvo
Replies: 0
Views: 114
05-22-2020, 12:47 PM
VW
Replies: 1
Views: 108
05-20-2020, 01:31 PM
AA+MHH
Replies: 2
Views: 284
05-19-2020, 03:20 PM
Land+Rover
Replies: 2
Views: 242
05-16-2020, 08:48 PM
Users browsing this thread: 1 Guest(s)