Hardware and Software for SPS Programming

Flashing firmware/software, in Opel world, until 2010 at least, have absolutely nothing to do with the immobilizer part, which is stored in the eeproms of these units. You have a car for which the secret key has been lost, which now requires ECU reset, BCM reset, IPC reset, SDM reset and at least 1 new transponder key.

Hello,

Thank you for your advice,

I found a solution for my problem, 2 month ago i made a copy of my engine ECU with MPPS, so i just restore it with old file and now i just programmed everything perfect, now the key is not blinking and i don't have error concerning transponder.

After i flashed my old file, i'm not able to communicate with engine ecu via OP-Com, and also have an error on IPC : U2101-71 Invalid Data From BCM and car won't start and i have a F letter on Cluster

I precise that i bought this car with starting problem, some time it start sometimes not ....

Hi !

After some searchs, errors U2101-71 and U2105600 come when there is a problem of communication between engine ecu and others calculators, in most case the problem come from ECU (water damage or software problem => my case).

The problem is reading this ECU (mjd 6O3.S3) with MPPS, and the solution was to inject a full backup to it, and now i'm able to communicate with it.

Now i need to buy a transpoder to program everything together and normally it will solve my problem.

hi ,guys 
i have to program ECU  for Opel Meriva B ,2011;global tis not working
from the website acdelcotds you must use sps or sps2 ?
best regards

If you need only programm Immo funtion, read PIN code (carpass) from ecu and CAR, reset ECU by PIN code and in Immo, Programm immo funcion, ECU new installed..
Regards.

If you need only programm Immo funtion, read PIN code (carpass) from ecu and CAR, reset ECU by PIN code and in Immo, Programm immo funcion, ECU new installed..
Regards.
i have to program only ECU engine,with  global tis ,i have error E4419;reset doesn t work

[font="MHH Font", Calibri, sans-serif]from the website acdelcotds you must use sps or sps2 ?[/font]
best regards

Why don't you  try Engin07 solution?