To obtain your registration code, please send an email to [email protected]
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

LED Pure Vision schematics

1
Hello. 
I have a different problem than most of the questions that are put here, I have a Renault Pure Vision LED parts, projector lens+headlight ecu+wire harnes, all the parts from a damaged car, so I'm training to do a retrofit to another car. The problem is that I tried to see if everything is working fine, but i I’m stuck. I manage to find only the low beam. Maybe somebody with more experience and some schematics can help me.

The headlight main plug have 6 wires pins, in the middle 2  are bigger, and if I put 12v+ on pin 3 and 12v- on pin 4 then I have low beam. What do I have to do for high beam?  Can somebody please help me?

                           
Thanks given by:
2
The one lights up when connected to power because it uses it as a DRL and stays illuminated constantly. And if it is like other Nissans it needs to see a coded signal from the combination switch through the CAN or LAN communication lines/wires? The combination switch is not a simple on/off switch anymore, it sends out a digital signal when it is operated. Youmost likely will need a switch also if you want to control it with the OEM headlight ECU unless you just make a simple high beam circuit control usain fa relay to power high beams on when needed )
Nissan diagnostic specialist! PM if I can help!
Thanks given by: pantera_roz99
Users browsing this thread: