Hey guys! i dont post for help often, im a very experienced tech in all automotive systems, but i need help for this one, and it might be a little long.
So to try and make a long story short, i work for a car dealership that buys newer salvage vehicles, mostly flood damage, electrcal, or lightning strikes, which is what this silverado is.
So here is the issue i have, in order to repair these types of cars, i usually have to do one or two modules at a time, until it points me to the next module, well basically when i replace the module, i use techline connect/SPS program the new module and it is good to go, when i connect a vehicle to SPS, it picks up what modules are supposed to be in the car and shows you only those modules, well basically, all of a sudden the trailer brake and trailer lamp module are now gone from the selection, and i replaced them but now cannot program them...
the crappy thing is since this is a salvage vehicle, its warranty is void, the truck is literally brand new only 3k miles on it, i tried calling ACDelcoTDS for help, but since the truck no longer has a warranty, they wont help me, im stumped now because i dont know any other way to program these modules for this truck.
has anyone else had this issue or know what to do?
I have all kinds of programming equipment, alot of experience soldering big and nano, i have an HDMI microscope oscilliscope and anything and everything, so if anyone has any suggestions, i am definitely capable of doing it
i dont know of any 3rd party software to program the modules on the bench....but if anyone can help it would be greatly appreciated, oh and im in the eastern US by the way if that info is needed, thanks in advance my fellow tech brethren!
So to try and make a long story short, i work for a car dealership that buys newer salvage vehicles, mostly flood damage, electrcal, or lightning strikes, which is what this silverado is.
So here is the issue i have, in order to repair these types of cars, i usually have to do one or two modules at a time, until it points me to the next module, well basically when i replace the module, i use techline connect/SPS program the new module and it is good to go, when i connect a vehicle to SPS, it picks up what modules are supposed to be in the car and shows you only those modules, well basically, all of a sudden the trailer brake and trailer lamp module are now gone from the selection, and i replaced them but now cannot program them...
the crappy thing is since this is a salvage vehicle, its warranty is void, the truck is literally brand new only 3k miles on it, i tried calling ACDelcoTDS for help, but since the truck no longer has a warranty, they wont help me, im stumped now because i dont know any other way to program these modules for this truck.
has anyone else had this issue or know what to do?
I have all kinds of programming equipment, alot of experience soldering big and nano, i have an HDMI microscope oscilliscope and anything and everything, so if anyone has any suggestions, i am definitely capable of doing it
i dont know of any 3rd party software to program the modules on the bench....but if anyone can help it would be greatly appreciated, oh and im in the eastern US by the way if that info is needed, thanks in advance my fellow tech brethren!
