Need full bdm ford kuga DCM 3.5 DV41-14C204-CG(CH, CJ, CK, CL or CM).

Pls help me.
Need full bdm for FORD kuga 2016, 2.0 tdci 163hp
Ecu: delphi
Part number: DV41-12A650-CG
Software: DV41-14C204-CG(CH, CJ, CK, CL or CM.

Somebody flash sw from another car and ecu is KO by obd. I read out with galleto (ktaq no work). And flash is bad. 
Thx for help friends.

did you try IDS?

i have only kess obd

did you try IDS?

Ids will not work if you flash wrong file,only full bdm or ucds can solve this on this ecu type.

I made own flash from bdm read with bad flashed file. Used good calibration. Car want start but than i see PCM. Than reflash with ids and work. (ucsd no work with wrong flash, and vbf loader with death modules dont work too).

I made own flash from bdm read with bad flashed file. Used good calibration. Car want start but than i see PCM. Than reflash with ids and work. (ucsd no work with wrong flash, and vbf loader with death modules dont work too).

Hi Guys !
I have dead one ecm like this  for FORD kuga 2016, 2.0 tdci 163hp
Ecu: HELPHI
DV41-12A650-CG

Someone can share one full reading of mcu + eeprom ?

Thank you !