To obtain your registration code, please send an email to [email protected]
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Smart 451 TCU / TCM coding and flashing

1
Can this TCU be coded or firmware updated on the bench?
The wiring diagrams suggest it maybe possible, but I'm not sure if the SAM has a role in the process.

Thanks.
Panasonic CF-H2, CF-20 (Win7/10, Xentry-DAS, Vediamo, DTS)
Open port 2.0, VCXSE, C3. (Retired newbie, still learning).
Thanks given by: frikitiki
2
(02-06-2024, 03:14 PM)Expat_Mat Wrote: Can this TCU be coded or firmware updated on the bench?
The wiring diagrams suggest it maybe possible, but I'm not sure if the SAM has a role in the process.

Thanks.

Update:
Quick answer: Yes.

Long answer: Yes both DAS and Vediamo.

How:
Grab your favorite VCI (I used SM2 with the bench cable - exposes 12v, Gnd and Can bus)
  12v - pins 1 & 8.
  Gnd - pin 4 
  Can Hi - pin 13
  Can Lo - pin 14
  (optional) 12v - Pin 31 (only needed for flashing).

Connect to right hand connector using diagram below.

+-------------------------------+
| 1  2 |  7 .  .  .  .  .  . 14 |
|      | 15 .  .  .  .  .  . 22 |
| 3  4 |------------------------+
|      | 23 .  .  .  .  .  . 30 |
| 5  6 | 31 .  .  .  .  .  . 38 |
+-------------------------------+

Connect with DAS or Vediamo full access to eprom for fault reading/clearing, coding etc.

Pin 31 enables access for firmware updates either by DAS or Vediamo.

That's it.

Matt.
Panasonic CF-H2, CF-20 (Win7/10, Xentry-DAS, Vediamo, DTS)
Open port 2.0, VCXSE, C3. (Retired newbie, still learning).
Thanks given by: karlos111 , pesona , LUNA-trans , ricardo_sx , frikitiki
3
Hi mate

I'm trying to update my TCU but DAS cannot see my cff file, can you please advise what is the procedure with DTS/vediamo? I don't seem to have any 451 files in my library 
my car is 451 turbo
hw: 451 545 02 32
sw:4514469095
vin WME4514322K070323

thanks in advance
Thanks given by:
4
Easy enough to do with Vediamo
Thanks given by: karlos111
5
I'll give it a try
Thanks given by:
6
It worked, it was really easy as you said 
Thank you!
Thanks given by:
7
Hello everybody, 

Can i use ktag or kess to this job?

Thank you.
Thanks given by:
Users browsing this thread: