Hi guys.
I have a w251 with a new m272 ecu.
After scn coding, it shows some error.
Unknown control unit variant. Limited range of diagnostic.
Scned with a new profi_cd with 05/16 xdos(das)
System is unmodded from offline/special pass etc.
*this same system has also did some ecu/vgs scn without any problem. Only this.
But using a 03/15 xentry, everything works fine.
But of course i cant initiate scn from there as it will trigger lots of blacklist, and it has alot of mods with it.
Is there any quick fix for this?
I have a w251 with a new m272 ecu.
After scn coding, it shows some error.
Unknown control unit variant. Limited range of diagnostic.
Scned with a new profi_cd with 05/16 xdos(das)
System is unmodded from offline/special pass etc.
*this same system has also did some ecu/vgs scn without any problem. Only this.
But using a 03/15 xentry, everything works fine.
But of course i cant initiate scn from there as it will trigger lots of blacklist, and it has alot of mods with it.
Is there any quick fix for this?
~If I helped, press "thanks" and "reputation". Thanks!~
