VAG PROGRAMMING

Good morning,I hope you are fine while everyone is at home because of corona virus.Now I have much time to search in web and find solutions for some problems.So,I own original VCP and Can Tie Car.I know I can do many things with them in Vag group,but always keep on looking for ways in programming.Using VCP,I can not find the right file in VAG database if I have to flash-reprogram a control unit and I am afraid to go in next step.If I was sure for this file,I would test it 100%.With CTC as passthru I think the problem is similar.I bought one VAS 5054 head from ebay,but I do not trust it very much.I tried to communicate with local dealer,they want to buy the original head and pay annual subscription.Believe me,it is a very expensive solution in Greece.So,whwt do you suggest,is there any solution?Have a nice day,,,,

There are sellers like me...who help you make dealer job for small amount...if u plan to do it ur own self...u need a geko id and pass...if u want to know the correct files...u can check the etka...it will give u information about the part and software as per ur vin...!!

Sent from my GM1911 using Tapatalk

Ok,what exactly I need to do it?I mean what hardware and which installed software in my pc?It needs special windows or it works in any version?

Chinese vas5054 and odis service and engineering is more then enough....unless u want to make keys or adjust mileage....u can make keys with odis but it needs to be precoded from dealer....for odis u can search in forum

Sent from my GM1911 using Tapatalk

Hi , I can help you 
If you send me Vin nr I can tell you what flashfile to use for what controller you need, like ecu , tcu, bcm ect.
If you dont have flash file you can get it here
www.autodiagnostics.org.za

If this helps give thanks

---

Vcp is capable of flashing almost all controllers on Vag

hello sir !

VIN : WVWZZZ3CZAE099171
and i did replace the mechatronic and are searching after the right file there has been a lot of problem with both clucthes and the mech unit i would realy need your help brgds.!

hello sir !

VIN : WVWZZZ3CZAE099171
and i did replace the mechatronic and are searching after the right file there has been a lot of problem with  both clucthes and the mech unit i would realy need your help brgds.!

You need v0693z320AM___getriebe_DSG_cf3z_sw for this car.

hello sir !

VIN : WVWZZZ3CZAE099171
and i did replace the mechatronic and are searching after the right file there has been a lot of problem with  both clucthes and the mech unit i would realy need your help brgds.!

You need v0693z320AM___getriebe_DSG_cf3z_sw for this car.