Thread title:
X290 EPS205_ZF – how to complete rack/end-stop teach-in after learned values reset?
Post:
Hello everyone,
I am working on a Mercedes-AMG GT43 4MATIC+ X290 (290.659, MY2022).
The steering ECU is:
EPS205_ZF
Variant: EPS205_ZF_EPS213_2305
After the learned values were reset, DTS Monaco shows:
With DTS Monaco I can see the reset routines:
I would like to know the correct procedure to complete the steering rack / end-stop teach-in after the learned values have already been reset.
How can I change the status from:
teilweise gelernt
to fully learned?
Is the learning completed automatically by a specific steering / driving procedure, or is a dedicated routine required?
Can this be completed with DTS Monaco, or is XENTRY Guided Functions required?
If anyone has experience with EPS205_ZF on X290 / W213 / related platforms, I would appreciate any information about the correct teach-in procedure.
Thank you.
X290 EPS205_ZF – how to complete rack/end-stop teach-in after learned values reset?
Post:
Hello everyone,
I am working on a Mercedes-AMG GT43 4MATIC+ X290 (290.659, MY2022).
The steering ECU is:
EPS205_ZF
Variant: EPS205_ZF_EPS213_2305
After the learned values were reset, DTS Monaco shows:
- Left end stop: teilweise gelernt
- Right end stop: teilweise gelernt
- Center offset: 0
- Rack travel: approx. 144 mm
With DTS Monaco I can see the reset routines:
- Reset learnt values - Rack length and offset
- Reset learnt values - Straight run offset
I would like to know the correct procedure to complete the steering rack / end-stop teach-in after the learned values have already been reset.
How can I change the status from:
teilweise gelernt
to fully learned?
Is the learning completed automatically by a specific steering / driving procedure, or is a dedicated routine required?
Can this be completed with DTS Monaco, or is XENTRY Guided Functions required?
If anyone has experience with EPS205_ZF on X290 / W213 / related platforms, I would appreciate any information about the correct teach-in procedure.
Thank you.
