To obtain your registration code, please send an email to [email protected]
Thread Rating:
  • 24 Vote(s) - 3.17 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Help with MB SDConnect Mux update

1
Hi. I had started another thread before for software problem with Xentry, but I managed it with reinstalling a little newer version (05.2012 to 07.2014).

Installation was successful, and I started configuring SDConnect with Dell D630 on the car.

When I was in menu options, always got some message for important firmware/software update. Finally I decided to do that, around 60% update stopped and showed error (I searched after that, cause probably were batteries)

Now mux number is 00 (before was 02), and in configuration says NO WLAN MODE.

So, I have signal to device via green cable, in sdconnect info, now there isn't ip address field, but just mac address.

Any help to "turn on" wlan mode again?
If I helped you, press Thanks & Rep+ buttons.
Thanks given by:
2
How is your SW version now (compare the file names at the toolkit folder with the version info from the SDconnect LCD)?

If SW update was fine, you have to reconfigure your mux. Batteries are not necessary any more at this step, just select configuration from the SDNC icon at the taskbar.
Thanks given by: Tawe
3
(11-29-2016, 11:38 AM)DBmhh Wrote: How is your SW version now (compare the file names at the toolkit folder with the version info from the SDconnect LCD)?

If SW update was fine, you have to reconfigure your mux. Batteries are not necessary any more at this step, just select configuration from the SDNC icon at the taskbar.
SW update stopped at a half way. Now don't want to start (batteries are also bad). Shows some error: DCDI_e ErrorCode=201 (201)

Later I will post more info Smile
If I helped you, press Thanks & Rep+ buttons.
Thanks given by:
4
SOLVED: I putted in new batteries, software update was succesfull and everything is fine Smile
If I helped you, press Thanks & Rep+ buttons.
Thanks given by: DBmhh
Users browsing this thread: