To obtain your registration code, please send an email to [email protected]
Thread Rating:
  • 12 Vote(s) - 3.33 Average
  • 1
  • 2
  • 3
  • 4
  • 5

What are the cause of these fault codes?

1
Hello!
I have 2002y manual transmission m112 w211. I can't figure out the cause of these fault codes. Please help!!!

P203D-001 Angle variation of camshaft to crankshaft. Camshaft signal (maximum angular variation in "advanced" direction (P1999)
P2003 Malfunction of secondary air injection (P0410)

SBC - These have the small "f"

C261D Hydraulics fault: Brake operating unit (BOU)
C25D8 Inspect wheel brakes for mechanical faults
C2514 Hydraulics fault: A7/3y1 (Left front seperating valve)
C22BD Hydraulics fault: Pressure regulator ,Right front wheel
Thanks given by:
2
From the engine fault codes, you have the timing of the engine which is incorrect, so you have to check for the timing chain and camshafts, but this fault code only occurs in the 271 and 272 engines, i didn't have this fault code on a 112 engine in my life. Also you have the secondary air injection which is the air pump, try to see its hoses maybe one of them is not good, or if its not then replace the pump

From the SBC, try to take the air out of the 4 wheels from the car by compressing the brake with a specified tool, and also make sure that everything is fine in actual values.

Regards.
Thanks given by: Ganbold , bawarek , Mercerwin
3
(01-23-2017, 09:49 AM)Ganbold Wrote: P203D-001 Angle variation of camshaft to crankshaft. Camshaft signal (maximum angular variation in "advanced" direction (P1999)
P2003 Malfunction of secondary air injection (P0410)

1.Maybe chain extended if you hear noise from front part of engine.
2.Nothing special, check vacuum lines in front of engine.


(01-23-2017, 09:49 AM)Ganbold Wrote: SBC - These have the small "f"

C261D Hydraulics fault: Brake operating unit (BOU)
C25D8 Inspect wheel brakes for mechanical faults
C2514 Hydraulics fault: A7/3y1 (Left front seperating valve)
C22BD Hydraulics fault: Pressure regulator ,Right front wheel

Like Ganbold said, take the air out of the 4 wheels and check lines on leak.
Mercedes-Benz - 'The Best or Nothing'
Thanks given by:
4
Can i take the air out using mb star 4 or do i have to use special tool?
Thanks given by:
Users browsing this thread: