To obtain your registration code, please send an email to [email protected]
Thread Rating:
  • 19 Vote(s) - 3.21 Average
  • 1
  • 2
  • 3
  • 4
  • 5

[SOLVED] 2002 E320 (210.065) hesitation

1
hi guys,

I'm working on a 2002 E320 (210.065) which hesitate once in a while

Symptoms are exactly the same as if the brake pedal was depressed during acceleration causing loss of throttle response. Throttle response comes back after 1 or 2 seconds.

Car had Brake light Switch fault code in memory so I replaced the switch.

Still have same problem.

I'm going back tomorrow to continue the diagnostic. I'll watch for BLS data while driving for wiring problem but I wanted to know if this symptom brings memory to some of you guys ?

Thanks for your help
Thanks given by:
2
# 1 make sure the battery is not dry .Ive seen these batteries cause weird problems caused by its location. I dont know why but the water seems to dissappear even though it still starts the car somehow
#2 does it really feel as if the ESP is applying the brakes or is it a lack of power from engine .

#3 about the only thing that will NOT leave a code is fuel supply (pump going bad) as there is no fuel pressure sensor on E320
#4 using DAS(xentry) only (no aftermarket diagnosis sys) check the 'actual values' in the ESP menu to make sure the brake light switch contacts are fuctioning correctly . .after installing a new switch the white plunger rachet must be pulled out with the pedal depressed then released to set the initial point. it should click about 8 times as it sets the IP
#5 if you are NOT using DAS u can forget about accurately diagnosing anything but the basics NO MATTER WHAT the maker claims about their scanner. Im sure there are plenty of other codes in the car that either u are overlooking or simply not seeing. If all else fails post a screenshot of quick test results
Thanks given by: MrPhil
3
It feels exactly like if throttle was going into limp mode.

I've found that on identifix.

Will keep u posted after the job

Code:
SUBJECT: DEALER TECHNICAL BULLETIN 24/96

24/96-1  RECALLS AND SERVICE CAMPAIGNS: WHEN REPAIRING ANY CAR, ALWAYS CHECK THE VEHICLE MASTER INQUIRY FOR OPEN CAMPAIGNS

24/96-3  GROUP 43 - ALL MODELS WITH ASR AND 722.6 TRANSMISSION ASR MIL LIGHTS, THROTTLE IN LIMP-HOME, INTERMITTENTLY:  Customers may complain of the ASR Malfunction Indicator Lamp (MIL) illuminating and the throttle entering limp-home mode (reduced throttle response) intermittently. If this occurs at idle, the engine speed will change audibly when the throttle enters limp-home mode. The problem may be difficult to reproduce at the dealership. In these cases, please check the transmission range selection switch (S16/10). With the HHT (on the Electronic Transmission Control (ETC) actual values screen), look carefully for a brief fault indication (letter "-F-") while a driving gear (e.g., "D") is selected. If a fault indication is noted, the switch should be replaced. Note that a fault may be indicated when shifting between gears, especially if the shift lever is moved slowly - this does not indicate a faulty switch.



K. Drexl
Service Engineering
KDdg
10-7-96
Thanks given by:
4
So I went back to the garage , drove the car for over an hour and everything was fine. The road was frozen so ESP was cuting fuel very often but this had nothing to do with the previous complain. So I teached the garage owner about ESP system + ice 1087

1st complain was about throttle not responding once in a while.
I think my first call was a good one. BLS was going to "on" by itself intermittently and was (as a safety algorithm) preventing the throttle to open (at least , that's my understanding).

The new BLS installed, there's no more throttle loss.

thanks for your time!

BTW... I run Xentry PassThru so I wasn't able to connect via the 38pin connector.
I'm now looking to buy a C4... Fing32
Thanks given by:
Users browsing this thread: