MHH AUTO

Full Version: china ktag and edc16cp42
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2
Hi.
The car was tuned and closed EGR in September last year. Yesterday a particulate filter was cut out. Today I tried to connect the KTAG to edc16cp42 and got the error "check the power and connection". I changed the positonon frame, took another Chinese KTAG, ran it on another laptop. The processor on the ECU buzzes, but the block is not identified. Voltage from 12 to 15 volts.
I have ori and tuned file, but i can't write it)
Any ideas?
have you tried back in car just in case
(06-04-2017, 01:45 AM)@[email protected] Wrote: [ -> ]have you tried back in car just in case

sure, ECU work fine
not broken 100%
is it hardware 1 or 2
(06-04-2017, 02:18 AM)@[email protected] Wrote: [ -> ]is it hardware 1 or 2

i don't know.

maybe its a bad bdm port? how to fix broken bdm?
solder some pins on , should be a set in your ktag bits and pieces
look, i think my bdm port broken.
Maybe, i can write by obd with orig kess or programm with someprogrammer S29CD016G ?
is it a nissan pathfinder ? dont think kess covers it
(06-04-2017, 03:07 PM)@[email protected] Wrote: [ -> ]is it a nissan pathfinder ? dont think kess covers it

infinity fx30d
Pages: 1 2