To obtain your registration code, please send an email to [email protected]
Thread Rating:
  • 41 Vote(s) - 2.78 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Comand NTG1 after update not start

10
Unplug COMAND, wait 10 seconds, plug it back in. Wait and see if you hear the DVD drive to start up, then press the power button.
Thanks given by:
11
You need to desolder flash memory from bottom side of mainboard. And reflash it with programmer with true firmware for you command model (BEXXXX). Only that i can reanimate ntg1 after bad fw update..
Thanks given by: daxxer
12
(05-19-2015, 07:01 AM)4matic Wrote: You need to desolder flash memory from bottom side of mainboard. And reflash it with programmer with true firmware for you command model (BEXXXX). Only that i can reanimate ntg1 after bad fw update..

have you more info about it and the true FW for the right model ? Itwasntme
_Offer TOKENS for VVDI MB BGA Tool or all VVDI2 activations - Instant_


Thanks given by:
13
Yes, i fix some ntg1 after bad update. Need model and one bottom flash from this model. After program that flash comand go on, but need update firmware with CD again. Only on working motor on car, not on ignintion(VERY important).
Thanks given by: plasticman1971 , daxxer , KG7222
14
Can you upload the .bin file of flash. Thanks
Thanks given by:
15
Hi

I have the same problem. The Mercedes logo appears but the device does not start. Can someone give me the dump for the flash and the firmware?

Best thanks!
Thanks given by:
16
You updated your COMAND and it's a brick now or did you not update and it won't start? In case of the latter, check for an open MOST ring (orange fiber optic cables) for damages or simply open connector. Also a defective MOST device will cause the ring to be open and it won't work.

Turn on ignition and check if you have 3 - (---) in your cluster display for all MOST menus like telephone, navigation, audio.
Thanks given by:
Users browsing this thread: