To obtain your registration code, please send an email to [email protected]
Thread Rating:
  • 13 Vote(s) - 2.69 Average
  • 1
  • 2
  • 3
  • 4
  • 5

W211 SAM DRIVER

1
Hi,

I will ask some about sam driver side.. I want disable the status check off sbc on the sam module. I know that pin 4 on sbc go to sam module for system check. When ignition is not on or no key in ezs, when i pull out the cable from sbc give the ic red warning.. This error come from sam module. Can i disable this warning with devloper mode in the sam module driver side? I see lot off acctuations but i dont know witch..
W211 2003

Rgs

Umka
Thanks given by:

Messages In This Thread
W211 SAM DRIVER - by umka - 03-16-2016, 06:01 PM
RE: W211 SAM DRIVER - by mersum1es - 03-16-2016, 06:30 PM
RE: W211 SAM DRIVER - by umka - 03-16-2016, 10:02 PM
RE: W211 SAM DRIVER - by mersum1es - 03-16-2016, 11:23 PM
RE: W211 SAM DRIVER - by umka - 03-16-2016, 11:37 PM
RE: W211 SAM DRIVER - by mersum1es - 03-18-2016, 02:27 PM
RE: W211 SAM DRIVER - by umka - 03-20-2016, 01:15 PM
RE: W211 SAM DRIVER - by umka - 01-01-2017, 07:13 PM
Users browsing this thread: