To obtain your registration code, please send an email to [email protected]
Thread Rating:
  • 28 Vote(s) - 2.96 Average
  • 1
  • 2
  • 3
  • 4
  • 5

2008 Dodge Sprinter - 3.0 Diesel No crank, no start

19
If it allows to crank it must start unless you broke something trying to fix it. Starter relay is controlled by engine ecu and it only allows to crank to crank when all conditions are met.
(12-09-2016, 01:53 AM)BigK Wrote: Otherwise is it possible I have a wiring issue inside the transmission harness....perhaps I should remove, cut it open and check all wires

Don't cut anything - if it cranks IT HAS TO START. You bypassed trans problem now you have to work out no start situation, that might be fuel supply or so..... You need to get back to basics...... drive authorization has nothing to do at this point. Believe me I see plenty of that junk.

I would strongly recommend checking ground point under drivers seat - same location for transmission VGS...... I am too lazy to check wiring diagrams but out of memory I believe fuel pump gets its ground out of same ground point as VGS module. Hope I helped. Its 11PM here where I live now, I need to finish my beer and go to sleep.

Hope I helped.
Thanks given by:
20
So some good news....finally got it started after replacing Crankshaft sensor, and putting some starter fluid, and a lot of cranks. It finally turned over, and is idling nicely.


Cleaned up the plug, crossed my fingers for the transmission plug, reconnected.

No Crank again....


Time to tackle this problem.


From the looks of it, there are 3 possibilities....

1. Wiring Harness can be damaged somewhere (I've read they touch exhaust and me lt a little sometimes)
2. Conductor Plate
3. Valve Body

I am going to go in that order of checking....I might skip 1 and go straight to 2.


Feels good to finally make some progress....to be fair the shop has been very busy and I haven't touched it since the last post, had some free time today and made a lot of progress.


Cheers and thanks efka for your expertise, enjoy the beer mate
Thanks given by:
21
Today replaced the conductor plate, replaced connector, tested all solenoids, all worked, wow the fluid was black....to be expected from a 400,000 mile sprinter.

Added fluid.


Turned the key.....



broom broom broom



hooray! Smile
Thanks given by:
Users browsing this thread: