To obtain your registration code, please send an email to [email protected]
Thread Rating:
  • 26 Vote(s) - 3.23 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Throttle stop adaptation problem

10
(06-28-2016, 07:28 AM)Rocinante Wrote: You can try and do the auto throttle actuator learn by just leaving the key in position 2 with the engine off for a couple of minutes..you will see and hear the actuator move to the end position then return... if it does this, then its learned and you don't need the sds as there might be a software bug in the learning process..

Thanks for advice

i tried this but with no success unfortunately

from ur experience is this a common bug in the software in these cars?
what the solution then?

i will install complete system if all my attempts failed and no suggestions to solve this

(06-28-2016, 10:38 AM)vanos batam Wrote: Make position zero on the screw thortle then adap with star

Thanks dear for advice

i made position zero but the adaptation process bar doesn't complete and quits
Remember the THANKS and + buttons if this helps youFing32
Thanks given by:
11
If the throttle actuator was bad, it could have damaged the fuel computer.. I have seen this many times as well... the not learning the throttle stop with the sds was a problem in the past with the software so it could show up again, but if it won't learn by itself with the engine off key in position 2 then something else is wrong...
________________________________________________________________________________​______

Remember the THANKS and + buttons if this helps you... It just makes me feel good
Thanks given by: diagnostix , bawarek
12
Hello, I have the same problem, than You wrote. I can't adapt the throttle actuator in das on a w215 CL500. Did You solve the problem?

Regards.

Dzsery
Thanks given by:
13
Check accelerator pedal %

(01-29-2017, 10:03 PM)gio777 Wrote: Check accelerator pedal %

your car need many times repeated learning process and 100% fixed your problem
MB Star2 Star3 Remote coding Anti Theft pin Map pin Renew FBS3 without special tool https://linktr.ee/SebaTechGeorgia 
Thanks given by:
14
If I turn the key to ignition position, the throttle actuator makes a quick open, that sounds like a clik, and nothing else. When I try to adapt it by das, the actuator don't move. The accelerator pedal result are good in das.

Tapatalkkal küldve az én LG-D856 eszközömről
Thanks given by:
Users browsing this thread: