To obtain your registration code, please send an email to [email protected]
Thread Rating:
  • 12 Vote(s) - 2.92 Average
  • 1
  • 2
  • 3
  • 4
  • 5

W211 ACC no heat problem Solved

1
Hi i have a problem whit this car,
No fault codes in ACC, but no heat. I replaced heat exchanger shutoff motor.
Its not helped me.
When i actuate left or right blend actuator motor i got a heat, but right away when i log out its stopped produce heat.
No internal fault no mechanical fault etc.
Looks like ACC module giving wrong data.

Can somebody point me what to do?
If i helped DON'T forget THANKS & REPUTATION button.
It just makes me feel good Thankyou
Thanks given by:
2
(11-15-2016, 07:23 PM)Raints Wrote: Hi i have a problem whit this car,
No fault codes in ACC, but no heat. I replaced heat exchanger shutoff motor.
Its not helped me.
When i actuate left or right blend actuator motor i got a heat, but right away when i log out its stopped produce heat.
No internal fault no mechanical fault etc.
Looks like ACC module giving wrong data.

Can somebody point me what to do?

What are readings of all temp sensors?
Thanks given by: Rocinante
3
I checked all readings normal, i will double check tommorow?.
If i helped DON'T forget THANKS & REPUTATION button.
It just makes me feel good Thankyou
Thanks given by:
4
Please post a complete short test as well as check the outside temp sensor reading in the instrument cluster..
________________________________________________________________________________​______

Remember the THANKS and + buttons if this helps you... It just makes me feel good
Thanks given by:
5
Here are all readings.

Attached Files
.pdf

das_scco_20161116_0953_PKW211208WDB2112081B441686_W211ACC.pdf

26
10.43 KB
.pdf

das_scco_20161116_0954_PKW211208WDB2112081B441686_w211blend.pdf

22
10.22 KB
.pdf

das_scco_20161116_0955_PKW211208WDB2112081B441686_C-ACCmulti.pdf

21
8.21 KB
.pdf

das_scco_20161116_0955_PKW211208WDB2112081B441686_w211rblend.pdf

19
10.23 KB
.pdf

das_scco_20161116_0956_PKW211208WDB2112081B441686_W211IC.pdf

26
9.78 KB
If i helped DON'T forget THANKS & REPUTATION button.
It just makes me feel good Thankyou
Thanks given by:
6
Front Sam driver chip. See instructions from YouTube.
Thanks given by:
7
Ok i saw this instruction.
But i get heat when i actuate left or right blend motor.
If i helped DON'T forget THANKS & REPUTATION button.
It just makes me feel good Thankyou
Thanks given by:
8
One thing i dont understand, why i get different AMB temp readings in ACC and IC?
ACC is 5 degrees and IC is 13.
I checked that heat exchanger shut off is working correctly.Heater core is warm enough.

ACC should get same readings from IC over can?

Thanks in advance!
If i helped DON'T forget THANKS & REPUTATION button.
It just makes me feel good Thankyou
Thanks given by:
Users browsing this thread: