need help Astra G 2.0 DTI MAF Sensor

does someone know what the value of the maf sensor need's to be on max load?
the car is Opel Astra G 2.0DTI the maf values now are 210-230mg/s idle and on max load it goes to 880mg/s
I put remaped 130+hp, remap was made on this forum by betrescudan
but the car feels same after remap, I think problem is MAF sensor I try from other same car but power was even lower, maf value at max load was around 800mg/s

check turbo presure - may be it is too low

turbo is ok, desired presure 2.0bar actual map presure is 1.9-2.0bar. And max injected fuel is 48mg/s in remap file max is 53mg/s, maybe injection pump ecu have limiter? Pump is PSG5

today I test car with brand new MAF sensor, maf value now goes to 1050mg/s on max load, car feels a bit more sharper but nowhere near 130hp, and max I.Q is the same 48mg/s
what could be the problem?

1. may be smoke maps is not edited or some other IQ limiters
2. you never have 130 HP without hardware changes for this engine

1. may be  smoke maps is not edited or some other IQ limiters
2. you never have 130 HP without hardware changes for this engine

This is not true.
WIth 49 mg fuel at 4000 rpm, you are already at 130 HP.
I have my own remap for the same engine and it feels very good. Torque is now 290 Nm
So, no problem to be at 130 Hp.

Yeah, i know, the thread is tooo old, but  it may be useful to other users now.