To obtain your registration code, please send an email to [email protected]
Thread Rating:
  • 18 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5

W212 OM 651 fuel high pressure issue SOLVED

1
Hello.

I have a problem whit this car.
In idle speed high pressure is starting fluctuate, when engine temperature is aprox. 50-60 degrees.
No fault codes.
When engine cold all okay and when fully warmed also okay.
Just in the mid range temp,fuel pressure starts fluctuate and idle speed also.
Specified value should be +- 20 bar not more but when symptoms starts its more.
I made a back flow test in injectors, they all even, replaced fuel pressure regulator
back side on the rail.
Its not helped me.

Can somebody point me what do to.
Any help is appreciate.

BR
If i helped DON'T forget THANKS & REPUTATION button.
It just makes me feel good Thankyou
Thanks given by:
2
you replaced Y74 or Y94 ?
Thanks given by:
3
I replaced Y74 pressure regulator valve.
Which is on the rail back not in front.
Y94 is quantity control valve which is on the high pressure pump.
If i helped DON'T forget THANKS & REPUTATION button.
It just makes me feel good Thankyou
Thanks given by:
4
Ah I see you mentioned even in the first message, my bad.
How does it looks like? Does idle speed jumps up or down for like 0.2-0.5 sec and then stabilize again? How often it happens (once in a 1 min/5 min)? Does engine shut off sometimes when it happens?
Thanks given by:
5
Y94 need replace
Thanks given by: Raints
6
Hi,

car runs fine.
I test it whit xentry and when the syptoms starts, i see that fuel pressure is starting to fluctuate more then it should be.
And its feel bad when i engage D or R and holding brakes.
Rpm plays up and down 50-100 rpm.
It happened when temp is aprox 50-60 degrees.
It appears and then it disapears. Yes its like 0,2 0,5 sec

(10-12-2016, 09:51 PM)yriy Wrote: Y94 need replace
How difficult is to replace it?
Looks like i should remove all intake/EGR.
If i helped DON'T forget THANKS & REPUTATION button.
It just makes me feel good Thankyou
Thanks given by:
7
In CDI should be y94 test. If pressure will fluctuate during y94 test then I think you will get change y94 test result.
If its impossible to perform test during malfunction then I recommend to replace y94.
Thanks given by: Raints , Bogdan Beb , Lysyde
8
Engine starts with Y74, but after a short time switches to Y94. Check also, at idle, fuel quantity( 3-9 mg/).To be sure if the Y94 valve is defective, detached the electrical connector and see if the problem persists. If not, maybe the injectors have a problem( nozzle).
don't forget to hit thanks and reputation buttons
Thanks given by: Raints , diagnostix
9
I replace Y94. valve and customer happy!Big Grin
If i helped DON'T forget THANKS & REPUTATION button.
It just makes me feel good Thankyou
Thanks given by: jihyu
Users browsing this thread: 1 Guest(s)