VAG EEPROM Programmer Setup 119 FREE

Hello

I am getting an error when read eeprom in ECU menu: "Rx Timeout..."
   
In Options menu "USB" is selected, and i can read the Fault codes.
But i can not read ECU eeprom.

Any help?

any help with "rx timeout"?

Please help with rx timeout on usb setting OR on com2 I get TX error

I can not bind with: USB Cable KKL VAG-COM 409.1 OBD2 II.
Chip Type：CH340.

Is this the problem ????

Thanks

Any solution for the engine's ecu Rx timeout error? :|

Hi... can i use vag eeprom reader with vcds cable??

Yes, you can but first run VCDS go to settings and make HEX-CAN USB Interface to normal KKL, there is setup for that.
Thanks to member Yoshimura.
Наздраве Приятелю!

I followed these instructions: https://sites.google.com/site/imnuts/home/install-setup-ross-tech-vcp-drivers

 But still no luck. I have aliexpress "HEX-V2 Dual-K & CAN <-> USB VAG/ISO interface" "B03-V2"
Do I still have to do some tuning for the driver or is it just that this cable does not work with VAG EEPROM? Any idea where this "normal KKL" setting can be found?

Work with vag k+can?

k-line is can work this soft!

Can use tactrix clone with this software?

Hi... can i use vag eeprom reader with vcds cable??

Yes, you can but first run VCDS go to settings and make HEX-CAN USB Interface to normal KKL, there is setup for that.
Thanks to member Yoshimura.
Наздраве Приятелю!

So if i set up vcds from Hex-Can to KKL i can use EEprom without any issue. Does it make a differenc if there is a CH340t or FT232RL Chip installed ?