To obtain your registration code, please send an email to [email protected]
Thread Rating:
  • 69 Vote(s) - 3.36 Average
  • 1
  • 2
  • 3
  • 4
  • 5

A class (start error)

7
(01-20-2011, 09:08 PM)energjia Wrote:
(01-20-2011, 05:38 PM)zoka6767 Wrote: I had same problem with one A-class .
The module had lost its coding , and I had to take ecu and imo ,and I went to an electrician to program them .

Sorry for my bad English , I hope my expirience would help Smile

Regards

sory for not explained well!
go to the CDI module and will pop up the HHTWIN and than go to 5 Controlle module adaption than 4 Identification

if you need more help contact me i will help with teamviwer.

all the best

sorry for delay in responding, been away from work ill. Thanks for all your input, i will go back to car on monday. so by going to HHTWIN then control module adaption, followed by identification your able to re sync with immo?
Thanks given by:

Messages In This Thread
A class (start error) - by techman1 - 01-19-2011, 12:19 AM
RE: A class (start error) - by energjia - 01-19-2011, 01:26 AM
RE: A class (start error) - by techman1 - 01-19-2011, 01:56 AM
RE: A class (start error) - by webmaster - 01-19-2011, 08:04 PM
RE: A class (start error) - by zoka6767 - 01-20-2011, 05:38 PM
RE: A class (start error) - by energjia - 01-20-2011, 09:08 PM
RE: A class (start error) - by techman1 - 01-22-2011, 03:12 AM
RE: A class (start error) - by energjia - 01-22-2011, 03:20 AM
RE: A class (start error) - by techman1 - 01-22-2011, 03:36 AM
Users browsing this thread: