Reputation:
1,105
Thanks Given: 172
Thanks Received: 1985 (64 Posts)
Posts:
105
Threads:
15
Joined: Mar 2013
1
11-02-2015, 01:46 AM
hi members
i am still facing a problem with my 211041 car
i have a shaking problem when engage in D or R position
i replaced then engine and gearbox mountings but still have a problem
when putting the selector in N or P rattling stops immediately and RPM rises abnormally
i checked the idling RPM in D and it is as specified
No faults in engine or transmission modules
thanks for
advice and help
Remember the THANKS and + buttons if this helps you
Thanks given by:
Reputation:
20
Thanks Given: 71
Thanks Received: 61 (13 Posts)
Posts:
124
Threads:
42
Joined: Jan 2015
check gear oil temp sensor
Regards
Reputation:
130
Thanks Given: 1270
Thanks Received: 635 (279 Posts)
Posts:
673
Threads:
17
Joined: Jul 2014
Check the Serpentine belt tensioner! Just remove the belt and cranck the engine and repeat your test!
“We, the unwilling, led by the unknowing, are doing the impossible for the ungrateful. We have done so much, for so long, with so little, we are now qualified to do anything with nothing.”
Reputation:
6
Thanks Given: 86
Thanks Received: 29 (21 Posts)
Posts:
223
Threads:
64
Joined: Sep 2014
Is it an automatic gearbox? Does the car kinda jerk forward when you put it in D?
Reputation:
6
Thanks Given: 158
Thanks Received: 59 (28 Posts)
Posts:
64
Threads:
3
Joined: Sep 2012
5
11-03-2015, 07:36 PM
(This post was last modified: 11-03-2015, 07:40 PM by benztech823.)
There is a one way clutch internal to the alternator pulley that goes bad and causes the belt tensioner to rattle when in gear. The noise will likely change frequency or even go away if the A/C is switched off while in gear. If you take the belt off and hold the alternator shaft the pulley should lock one way and free wheel the other. If its locked both ways replaced the alternator pulley.
Reputation:
6
Thanks Given: 86
Thanks Received: 29 (21 Posts)
Posts:
223
Threads:
64
Joined: Sep 2014
Your problem is more than likely going to be the torque converter located inside your gearbox...
Thanks given by:
Reputation:
1,105
Thanks Given: 172
Thanks Received: 1985 (64 Posts)
Posts:
105
Threads:
15
Joined: Mar 2013
hi dears
the problem was dirty valve body...after cleaning it improved almost 85%..am going to replace the hydraulic pump of steering and the steering shaft..
any word of help was immensely helpful
thanks
Remember the THANKS and + buttons if this helps you