GM TIS2000

I also need this copy

i can give you my user and password to do reprogramming online
send me PM

only for MHH member

that would be awesome [email protected]
-------------------
EDIT BY MODERATOR Yudi

Please READ the rules (HERE!)
Rule #10.
10: DO NOT post e-mail addresses on the Board

anyone ?

im still looking for gm nao 8.2008 or 10.2008

HAS ANY ONE GOT THE INSTRUCTIONS AND THE DRIVERS NEEDED to set up cardaq-plus to work with tis2000 NAO for programming and flashing
any way is it possible to make such a set up ?

go to drewtech site for drivers and call them ask for Joey for support.

Hello all. I'm a relatively new member who registered in November of 2014. I have posted a introduction today as well. I'm building a kit car that uses a C6 2006 Corvette electrical system. I'll be preparing to start the car soon and finally need help with the programing of modules and ECM.

Here is what I own. I have a original Tech 2 scan tool with the needed Candi module. I have just installed on my Panasonic Tough Book with Window XP the needed TIS 2000 NAO (06.5) software upgraded to 02/2007. The electrical system is based on a 2006 Corvette so I don't believe I need any further updates.

Can anybody help me with the info needed about a dongle or crack?

Hello all. I'm a relatively new member who registered in November of 2014. I have posted a introduction today as well. I'm building a kit car that uses a C6 2006 Corvette electrical system. I'll be preparing to start the car soon and finally need help with the programing of modules and ECM.

Here is what I own. I have a original Tech 2 scan tool with the needed Candi module. I have just installed on my Panasonic Tough Book with Window XP the needed TIS 2000 NAO (06.5) software upgraded to 02/2007. The electrical system is based on a 2006 Corvette so I don't believe I need any further updates.

Can anybody help me with the info needed about a dongle or crack?

Read this entire thread carefully and you will find what you need.

Kind regards Dx.

HAS ANY ONE GOT THE INSTRUCTIONS AND THE DRIVERS NEEDED to set up cardaq-plus to work with tis2000 NAO for programming and flashing
any way is it possible to make such a set up ?

I just purchased the Drew Tech CARDAQ-M and I'm trying to get this to work right now. did you figure it out yet??? I'll let you know if I find out how to assign the J2435 device for programming.